Brake Master Cylinder For MITSUBISHI AIBHI MB534481/MB534480/MB500673/MB82800/MR4494762/MB699830 DIA 15/16 inch

DIA:23.81mm
Mounting Size:Φ35/80/2-Φ9
Connetcing Size:M10 x 1.0
M10 x 1.0

OEM:

MB534481
MB534480
DORMAN : M390368

MB500673
MB828002
DORMAN : M39972

MB699830
DORMAN : M390156

MR449476

Model:

1990-1999 MITSUBISHI PAJERO II
1986-1996 MITSUBISHI L 200
1990-1996 Mitsubishi Mighty Max
1988-1991 Mitsubishi Montero
1990-1993 Dodge Ram 50
1989 Dodge Raider

1992-1995 Eagle Summit
1992-1995 Mitsubishi Expo
1992-1994 Mitsubishi Expo LRV
1992 Mitsubishi Mirage
1992-1994 Plymouth Colt

1997-2003 Mitsubishi Montero Sport
1992-1997 Mitsubishi Montero

REMOVING THE ORIGINAL MASTER CYLINDER

NOTE: Before beginning work，be sure vehicle is parked in a level area and that wheels are chocked to prevent unintentional movement.The master cylinder must be level during the procedure.

1.Disconnect the ground cable from the battery.

2.On manual brake master cylinders（except some Chrysler products），disconnect the push rod from the brake pedal linkage under the dash.The rod eyelet is attached to the pedal with a thru-bolt and cotter pin，nut or retaining clip。

NOTE：Some chrysler vehicles use manual brake master cylinders with a “pop out”pushrod. After removing the flange bolts，support the master cylinder and use a wedge between the flange and firewall to “pop”the pushrod from the piston.Do not separate the pushrod from the brake pedal linkage(see illustration).

3.Disconnect electrical leads from master cylinder's brake failure warning switch,if so equipped.

4.Clean the area around the brake line commections on the master cylinder.

5.Disconnect brake lines from the master cylinder and proportioning valve,if so equipped. Cover or plug lines to prevent dirt from entering and contaminating the brake system.

CAUTION: Do not allow brake fluid to contact painted surfaces as the fluid damages paint. If contact occurs,immediately flood the affected area with water.

6.Remove the nuts/bolts securing the master cylinder to the firewall or power brake booster.Do not remove power brake booster.

7.Remove the master cylinder from the vehicle.CAREFULLY remove and save any fittings,rubber hoses , clamps , plastic , gaskets or other components (including brake warning switches and proportioning valves) for installation on the replacement unit if necessary.

NOTE: If the replacement master cylinder is supplied without a reservoir,you must remove and transfer the reservoir from the original master cylinder to the replacement unit.Refer to the following instructions.

TRANSFERRING THE RESERVOIR

1.Carefully drain remaining brake fluid from the master cylinder.

2.Position the original master cylinder in a vise so the jaws clamp onto the mounting flange. Do not tighten the vise jaws on the master cylinder body! This will cause damage and void the unit's core value.

Contact us if you need more details on Brake Master Cylinder For Mitsubishi. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Brake Hydraulic Cylinder For MITSUBISHI、MB534481/MB534480/MB500673/MB82800/MR4494762/MB699830. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Brake Master Cylinder